› ›

BigMan200

About

Username
BigMan200
Joined
Visits
1
Last Active
Roles
Member

Comments

  • Repetier said: Deltas in V1 have only one resolution for all axes (taken from Z-Axis). The way it gets computed requires this and it normally works well. Print cube in 2 sizes and compare errors. I often see that one side is a bit smaller th…
    in Delta printer: x, y, z steps per mm Comment by BigMan200 November 2018
  • MartinH said: After re-flashing you need to send M502  ;read values from config M500  ;save values too eeprom or clear the eeprom befor flashing. Thanks for the codes / commands. Indeed: I raised EEPROM_MODE in the configuration.h by +…
    in Delta printer: x, y, z steps per mm Comment by BigMan200 November 2018