Batteau62
About
- Username
- Batteau62
- Joined
- Visits
- 7
- Last Active
- Roles
- Member
Comments
-
MartinH said: In the config tool, you have to tick the enable Z probing box, 1st option under the features tab,this will open the Z probe options half way down the page. For bl touch, you will also need to enable the servo support. When y…
-
Ok, that worked to get reasonable temps on thermistors. But I still get a fatal error, so I think the pins are not correct. Confused by Radds starting at T0. What would be the correct mapping for temp pins in configurator if they are plugged in like…
-
Update: I have the bltouch powered now, step down converter off of 12v bus. When I first turn the printer on the probe lights red and deploys twice. But I can't get the probe to deploy after, I've tried M340 S0 P700, M340 S0 P1800, M340 S0 P2200 and…
-
Yes! Thank you so much. One problem solved, a few more to go