Artesian3D
About
- Username
- Artesian3D
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
I attempted to print with the power plugged into another room and the MendelMax turned OFF. STILL getting loads of checksum errors and crashes! I feel like I've literally tried everything!
-
Hi again, I tested 2 other computers AND another known working PSU. The voltage on both was within .01 volts the entire time I tested everything. Even during a dry run... tons of checksums and failures. I already have a very good and very expens…
-
UPDATE for today: ... it just crashed while SD printing. All activity FROZE. All motors locked. Nothing happened. WHILE SD PRINTING! The host wasn't even open and the USB cable was disconnected! What in the world!? WHY???? How am I so cursed? So…
-
Thanks so much for responding! 1. The thermal runaway has basically stopped happening, but like I said whenever it did the host basically reported everything was perfect. I never saw those values change from what they were set to, watched it like …