Ander

Comments

• thank you. i have changed the hotend with its heater and sensor and the problem was gone. 

  in Extruder stops Extruding + Heatbed stops Heating in the middle of printing Comment by Ander May 2016
• Hi, thank you for your answer. this quite a while ago. but i haven't in town for long, and when i was back and started printing again, it worked. today did two little 10-15 min test prints, but then ran into the same problem like described above. No…

  in Extruder stops Extruding + Heatbed stops Heating in the middle of printing Comment by Ander April 2016