AmirNazir
About
- Username
- AmirNazir
- Joined
- Visits
- 4
- Last Active
- Roles
- Member
Comments
-
Now it's not about decoupling I can't control my heat bed before or during printing During printing the heat bed switch on and off randomly And can't switch it on before printing ND the pic in this link http://imgur.com/a/kbVfW
-
I did that and it was working good but suddenly it stopped working thermistor is doing well heat bed is doing well but the problem is in the heat bed control during printing it would work by itself without any problem but it shuts down again after…
-
http://imgur.com/a/kbVfW This is the link of picture I lost control of heated bed If I want to control it I should the two parts illustrated in picture touch each other and I think that would harm than ramps board If there was no direct contact bet…
-
I'm talking before decoupling i can't control it before the 1 component touch the 2 component in this pic of ramps http://imgur.com/a/kbVfW and it won't even work during making the object unless i make the touch each other and z after i deleted its…
-
about z i defined that but it's not working about decoupling It was working properly and the problem not just about decoupling I can't control it manually without making the two component in ramps connected just identified in the image previously it…
-
http://imgur.com/a/3sdio imgur.com/a/3sdio
-
imgur.com/a/3sdio http://imgur.com/a/3sdio