› ›

Allu_500

About

Username
Allu_500
Joined
Visits
6
Last Active
Roles
Member

Comments

  • Ok, found the issue, it was the power supply, swapped out to one that puts out 5.2v 1.25A and it runs great, but without cams, plug in a camera and it draws again too much, so need to get a powered usb hub.
    in Sequential printing issue Comment by Allu_500 November 2019
  • I'm using a pi3 b+, and the power supply is a 24v to 5v 3A step down, but you are right, it might still be the power supply as I haven't logged the voltage, and it might be just at the limit all the time, and drops in some occasions???? Feels just w…
    in Sequential printing issue Comment by Allu_500 November 2019
  • Did something change in the latest raspi server update? As this function does not work anymore after the update.
    in Upload directly to Server Comment by Allu_500 October 2019
  • I had this very same issue with 2 anycubic chiron's, need to configure 1 printer first, and then take a look at the name path when choosing the printer from drop down menu so you know which one it is, then keeping that printer on connect the other p…
    in Connection problems with two anycubics Comment by Allu_500 August 2019