Akex
About
- Username
- Akex
- Joined
- Visits
- 12
- Last Active
- Roles
- Member
Comments
-
Do you see that ? don't work i thing there are a bug in firmware with mixing if define that in configuration.h : #define NUM_EXTRUDER 3 #define EXT0_TEMPSENSOR_PIN TEMP_0_PIN #define EXT0_HEATER_PIN HEATER_0_PIN #define EXT1_TEMPSENSOR_PIN TEMP_0_P…
-
I find a solution but i think there are a bug in firmware! in my configuration.h i do that i comment this two line //#define EXT1_HEATER_PIN HEATER_2_PIN //#define EXT2_HEATER_PIN HEATER_2_PIN if you can find the bug...
-
don't work i thing there are a bug in firmware with mixing if define that in configuration.h : #define NUM_EXTRUDER 3 #define EXT0_TEMPSENSOR_PIN TEMP_0_PIN #define EXT0_HEATER_PIN HEATER_0_PIN #define EXT1_TEMPSENSOR_PIN TEMP_0_PIN #define EXT1_HE…
-
I will check that But in repetier host if i run heat on t1 or t2 and t3 all work , the heating do just in the first extruder I check tha now Thanks lot of repetier
-
That is my video If you need my setup or other ask me