OGHUGO
About
- Username
- OGHUGO
- Joined
- Visits
- 1
- Last Active
- Roles
- Member
Comments
-
OK, is there plans on trying to implement something like this? I know that in the settings you can have different settings for the heat for different materials such as PLA, PETG or ABS.. Also, I have another question, on the latest repetier server…
-
OK, so I covered up pin 1 with some electrical tape just as the guide. I made triple sure I had the correct pin.. the one on the far right when looking at the connector and once I connected it on to the server (pi) nothing.. the pi is not seeing …
-
I have 3 of the same printer and wanted to have all of them on this. one is still in the box.. Anet ET4+ with the stock firmware. website says this has a 32bit motherboard but not too sure what other info I can provide. so if the printer is off …
-
I have 2 exact printers and they are both running the same firmware.. One is on /dev/serial/by-path/platform-3f980000.usb-usb-0:1.3:1.0-port0 the other /dev/serial/by-path/platform-3f980000.usb-usb-0:1.5:1.0-port0 I cannot use /dev/serial/by-id sin…