AlterEgo

Comments

• I'm using a kartesian printer and babystepping worked fine till 0.92.3  I know that there is - unfortunately - no option for max pwm for fans. I wanted to test 12V fans in a 24V setup without changing all my profiles. The option is not really neces…

  in Rotary encoder jumps >100 steps in opposite direction during Z-babystep use Comment by AlterEgo November 2015
• Hi,thank you for your answer.  i had issues with my Rumba board and so i changed the firmware often last time. Babystepping worked fine with 0.92.3. Since 0.92.4 it doesn't work. My last try was yesterday (I downloaded the complete firmware). Meanwh…

  in Rotary encoder jumps >100 steps in opposite direction during Z-babystep use Comment by AlterEgo November 2015
• Hi, babystepping does not work since 92.4. The printer hangs completely after some clicks turning the wheel.  Tested on Rumba and Ramps 1.4, RRD Smart Controller (20x4).  Is it possible, that the settings of the rotary encoder cause this problem? re…

  in Rotary encoder jumps >100 steps in opposite direction during Z-babystep use Comment by AlterEgo November 2015
• One of next steps will be a interface for stand alone printer with touchdisplay. That interface will be much compacter as it is intended to run a pi or beaglebone. It will not offer everything, but the most important parts. For the full interface yo…

  in Repetier-Server do not stop/start properly Comment by AlterEgo February 2015