bpetrus
About
- Username
- bpetrus
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
All right! Where can I the z max homing switch?
-
Ok, but, if i allow the probe, then and I send "Z home" command, the motor sit down until Z min, after go down approx 40 mm. The motor strains, but not place... :-(
-
The Repetier firmware gives "unknown command" answer. (G30) The printer are CNC mode.... Why?
-
Right! This is my idea: https://drive.google.com/file/d/1zyfqD0u7M9DCGs1s37enWivfk_vqJHI4/view?usp=sharing Is this correct?
-
Well, I may not understand the principle: Can I upload an image?
-
Wery well! If I delete the negative Z data then the 3D printer is work. Thank you your advice!
-
I found in the configurator, but don't found in the configure.h. This is it?: #define ARC_SUPPORT 1
-
Well, meanwhile I found it: Enable arc support (G2/G3): is checked. Is the G02 format good, or G2?
-
Ok. Thank you... But, where to find this options?
-
Oh, wanderful! I uploaded with " #define EEPROM_MODE 2", now works! Is it worth rewriting for " #define EEPROM_MODE 1"? Thanks!
-
Well, this code: // ################# Misc. settings ################## #define BAUDRATE 115200#define ENABLE_POWER_ON_STARTUP 1#define POWER_INVERTING 0#define AUTOMATIC_POWERUP 0#define KILL_METHOD 1#define ACK_WITH_LINENUMBER 1#define KEEP_ALIVE…
-
Thank you for warning! :-) But. Now, the problem is that the set value is not remembered by the problem. If I turn off, or reset the arduino, then resets to the original 200 value. Even though I write the firmware, it stays at 200. :-( I set the …
-
Well, I'm hurried: If I reduced the max feedrate, then the motors are good....