› ›

Paul

About

Username
Paul
Joined
Visits
27
Last Active
Roles
Member

Comments

  • Hi Repetier, thank you for responding.The printer is quite large, about 1200mm high with working height 900mm.  The arms are quite long, at some stage I will probably make them shorter, but they will not be horizontal.  Below sections of the config …
    in Delta Homing issue. Error:A hit floor Comment by Paul August 2015
  • Hi LarsThank you very much for responding and your advice.  Problem was that I was too nervous and expecting the G30 to be triggered by me manually when it was much higher up.I now have the machine auto levelling.  Still need to dial it in to set Z0…
    in Z Probe not working with G30 Comment by Paul March 2015
  • Update:Using Repetier host v1.06 on Windows 7, firmware 0.92
    in Z Probe not working with G30 Comment by Paul March 2015