kreto
About
- Username
- kreto
- Joined
- Visits
- 1
- Last Active
- Roles
- Member
Comments
-
sorry wrong buttom
-
hiwhen i was running sprinter firmwarewhen uploading from "pc1"(w7 intel) with arduino ide 1.0.6 it worked fine when using "pc2"(w7 amd) to upload then it´s "skipped x steps" at the same line in print, three times in a row on same object then i uplo…
-
I had almost the same problem, but the sprinter firmware worked fine but in repetier firmware extruder was not running I swapped pin round (x = E0 and E1 = x) so then the extruder worked in sprinter i uncomment #define RAMPS_V_1_3 in pin.h under me…