BetterHalf
About
- Username
- BetterHalf
- Joined
- Visits
- 7
- Last Active
- Roles
- Member
Comments
-
After, dozens of test prints, taking apart the ramps and mega, straightening out and separating every cable, I finally got desperate and purchased a new ramps and mega clone. (I had not read the last reply here)While taking everything apart I notice…
-
Well, the change in baud rate has removed all log errors, but the problems with the extruder switch and no extrusion is still happening.Part way through the print, there is a momentary pause and a quick offset of the extruder postion, then the host …
-
I reinstalled the newest firmware lastnight at a lower baud rate (115200) and so far 3 prints and no log errors or failed prints. last firmware update prior to this was about 4 days while troubleshooting then a couple weeks prior to that. I am by no…
-
I'm using repetier firmware, not marlin. I ran the usb cable under the printer to avoid interference. There is about 50 mm and a 8mm thick sheet of uhmw between the usb and all components. The errors themselves are not really a problem, it's the e…