HotshotCandy942
About
- Username
- HotshotCandy942
- Joined
- Visits
- 1
- Last Active
- Roles
- Member
Comments
-
sorry for the late response but thank you for the help. It turns out that the temperature was actually correct either from the heated air or maybe heat creep but i took out my second extruder and heated it up to clean it and the other one did not he…
-
How would I switch to monitor the output power? Is there only supposed to be one line on the graph for 2 extruders? Also the nozzle that is off doesn't read just a little hot. If i turned extruder 1 to 180C then nozzle two reads also between 179-181…