Enlightx
About
- Username
- Enlightx
- Joined
- Visits
- 37
- Last Active
- Roles
- Member
Comments
-
Okay interesting update!! and do with some help analysing the gcodes! I use cura for my gcode generation. thought i would try slic3r see if i get same result. i didnt notice the issue. (i only ran for a while though) here is Gcodes for both and a…
-
Hi Found #define PRINTLINE_CACHE_SIZE 16 Changed that to 14. still got a pause. Then lowered it to 10 and still got a pause. Pause is always in the same spot. and also i have now tried with 2 boards, ramps 1.4/mega2560 and now a rumba both with …
-
Seems to have reappered in a reflash (i changed probe to inductive so had to reflash) were can i find the move buffer count so i can lower it? Thanks luke
-
just lowered z correction points from 7 to 5 (i was changing this on new firmware) think this may be whats killing the memory. time to look into a 32 bit due i think
-
Hi Back working on this again. I found an old arduino sketch for my older firmware dated 09/04/15 from the website. flashed this back on and no problem at all. just tried latest website code today and getting stops again. has anything changed be…
-
Hi iv just found month of arduino sketch from 09/04/15 flashed and working so far no issues. im printing from SD card LCD im using is reprap discount normal size setup with sd card (the common one) im also using auto level and z correction but al…
-
i did notice that while running create height map i get the following 15:43:05.735 : Z-probe:10.03 X:-50.00 Y:-50.00 zCorr:-0.01 15:43:06.850 : Z-probe:9.96 X:-35.71 Y:-50.00 zCorr:-0.01 15:43:07.956 : Z-probe:9.89 X:-21.43 Y:-50.00 zCorr:-0.01 15:4…
-
Okay im back on this now. i have updated via the website and flashed firmware. reenabled autolevel. reset the matrix and still not getting level print. Can someone explain or even show pic or video on how to do the step that involves using G132 S…
-
okay cool, just need to get a few prints finished while i have it level non autolevel mode then ill update and post back thanks for the help so far
-
can i use the website config tool for this or do i need to download from a git hub? i think website currently uses 0.92.2
-
Thank you got helping. I check the offsets by calibrating spots 25mm in front of each tower (points calculated using CAD) i change offsets untill all places read the same Z height when hitting peice of paper. Then the delta radius is calced by cha…