frogmangeek

Comments

• Thank you for advises , bed mesuring and distorsion correction do their job now   Regards, 

  in Z probe, M119 does ZminEndStop L while Z_probe is high Comment by frogmangeek May 2020
• I am wondering about X/Y probe offset, could you tell me if it s right :  https://photos.app.goo.gl/ykhyGucvrNbyffkN8 Thank you  

  in Z probe, M119 does ZminEndStop L while Z_probe is high Comment by frogmangeek May 2020
• here is my configuration.h /* This file is part of Repetier-Firmware. Repetier-Firmware is free software: you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Soft…

  in Z probe, M119 does ZminEndStop L while Z_probe is high Comment by frogmangeek May 2020
• Thank you for answer.  I don' t understand why Z_probe do high when trigerred and low when untrigerred whereas I didn't defined Z_probe_pullup 1.  Even more, I don't understand why if I activate repetier host Z_home button , Z axe go down to zero, p…

  in Z probe, M119 does ZminEndStop L while Z_probe is high Comment by frogmangeek May 2020