Opremdobro32
Hello,
I'm building a custom 3d printer using arduino 2560 and ramps 1.4. For X axis I use nema 17 motor with a TB 6600 driver, Y nema 23 also with TB 6600 driver and for Z axis and extruder motor nema 17 and A4899 drivers. I'm having trouble configuring the endstops. I have instaled three optical endstops blasini optical endstops. I've checked everything multiple times and the electronics are connected corectly. Tried everything. and combined almost everything in the mechanics part of the repetier firmware configuration tools and still have problems.
About
- Username
- Opremdobro32
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
Changed the homing position in printer settings to 180 and the Y axis is working correctly. Move increments are always the same now Steps per mm are the same as are the length, done the M502 M500 commands. I think I should change the position of th…
-
Thank you for your answer. I've done the changes and here is how it goes: It now homes incremental, it works. When homed, the M119 command sent to the printer it says: 17:33:30.110 : endstops hit: x_min:L y_max:L z_min:H. Is that the way it should …
-
For reference I'm sending this as a definitive explanation what the configuration looks like
-
Well I didn't check exactly what length, but I was thinking it should go constant speed until it reaches endstop. If I did understand you correctly, I should change the connector on the board to Y max position? And then change the direction of the h…
-
Sorry for bad explanation. I have an old Felix 1.5 3d printer which is controlled by repetierhost 2.16. I think the procedure for homing of the each axle should be the same on this custom machine, which is when manually pressed the home button, the …