StuartAndrews

About

Username
StuartAndrews
Joined
Visits
6
Last Active
Roles
Member

Comments

  • I set up the servo pin and probe to pin 11 and tried the suggested M340 P0 S10 or S90 and I still get no response from the probe. Is there a way to test that a signal is being sent to the pin or a way of checking that I have communication to the pin?
  • In the firmware configurator there is Z-Probe Pin selection drop down...  I have selected Digital Pin 11 and in the Servo Configuration there is a Servo 0  Pin dropdown - I have selected Digital Pin 11 and start position of -1. It seems contradictor…
  • Thanks @Repetier I have the three wire servo connector wired to Servo0 on the Ramps, I am assuming that I should select Digital Pin 11.  The two end stop connection is wired to Z-min ground and signal. I have checked and found other values for S so…
  • well one of the boards seems to work okay... the other now has text on the display....  However, it appears to be constantly cycling through the start-up and the green LED is flashing at the same rate. Have I damaged the board in some way????
  • I have cured it....  I reduced the contrast on the pot, and low and behold the screen displays the text now!!!!