NewUser

I have been trying to compile version .92 of Repetier for a Melzi board for 3 weeks now with no success. The online configurator is very confusing to me. Can someone provide the configuration.h file for melzi or instructions for the online tool? Have had some success with Marlin.

About

Username: NewUser
Joined: February 2020
Visits: 14
Last Active: March 20
Roles: Member

Comments

Thanks again for your help

in filament out setup in firmware help Comment by NewUser March 2020
Hi, in the Mechanics section I only see an option to either send a message to display or pause. No option to select high or low signal. I can choose the right pin but I only get a jam message on the display.

in filament out setup in firmware help Comment by NewUser March 2020
Thank You for your reply. You pointed me in the right direction. Going to look at the Rep-server.

in wifi config how to Comment by NewUser March 2020
Went back to my MKS gen v1.4 all is good but no wifi.

in Alternate firmware Comment by NewUser March 2020
Looked at radds, out of my price range at this time.

in Alternate firmware Comment by NewUser March 2020
Thanks, I will try that.

in Alternate firmware Comment by NewUser March 2020
Solved my problem by flashing an MKS gen v1.4 with Repetier and the display is working perfectly.

in RepRapdiscount full graphics smart controller won't work in Repetier Comment by NewUser March 2020
Repetier said: You are using pin 49 for some function which does not exist in your case. I think that is sd card detect pin. As it is not the default controller for melzi there is no valid pin definition in DisplayList.h (ui.h in older firmwa…

in RepRapdiscount full graphics smart controller won't work in Repetier Comment by NewUser March 2020
Nevermind, I figured it out.

in fustrated with online Repetier configurator Comment by NewUser March 2020