fandrom
About
- Username
- fandrom
- Joined
- Visits
- 1
- Last Active
- Roles
- Member
Comments
-
LJ12A3-4-Z/BY PNP
-
My new setups: Firmware: Repetier 1.0.3 , online generated. My board: Ramps1.4 with Arduino Mega 2560My Printer: Tronxy X5 Endstops: (have all the same endstops nornal open with two wires connected onboard to GND and S(Signal) , (+5V plug onboar…
-
Hi, I install now the inductive z-probe sersor LJ12A3-4-Z/BY (NO Normal open) 6-36V DC for hotbed-autoleveling to PIN 63 on Ramps1.4 ( AUX-2):brown: +5Vblue: GNDblack: PIN 63 on Ramps1.4 bei AUX-2 Problem-2: z-probe-sensor red-diode light on if i p…
-
MartinH said: (have all the same endstops nornal open with two wires connected onboard to +5V and GND, S(Signal) connector onboard ist free) This is a good way to destroy the 5 volt regulator on the arduino when a endstop is triggered.. …
-
RAyWB said: Guess your endstop wiring is not correct.if it´s mechanical endstops , normally open connected with two wires you have to connect 1 wire to S(Signal),the other one to GND. +5V is not connected in this case. Thank you RAyWB, …