PlaneMaker
About
- Username
- PlaneMaker
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
Thanks, I have no clue either why the screen goes off then comes back on. I've been using Cura to print off a job and unfortunately can't waste anymore time right now. I just got a shielded USB cable so a few days ago so when I get a break I will tr…
-
Well, I do not have this problem when I am using Cura to print. Also, when I try Repetier, I notice that the LCD screen on the printer goes blank every 5 seconds or so. With Cura, it does not do this.
-
Well, I set the nozzle temp to 215C and the bed to 50C and started a 3h:45 min print job. 15 minutes from the end, it stopped. The error is:Printing layer 664 of 692Printing layer 665 of 692 Communication timeout - reset send buffer block. I think …
-
Thanks. I have already tried unplugging restarting etc. etc. but that doesn't work. But I have reduced the bed to 50C and the nozzle to 220C and this seems to have helped. I'll see how it goes.
-
I'm having the same problem...just stops randomly mid print. No way to get it going again. Very Frustrating!! Windows server 2012 R2, Repetier 2.1.3, Tronxy X3A Marlin v. 1.0