LordFly
About
- Username
- LordFly
- Joined
- Visits
- 40
- Last Active
- Roles
- Member
Comments
-
Excellent, very good to know, thank you! I will consider it good enough the way it is
-
I just thought I'd follow up on this because I JUST NOW finally did this. The script is as follows: M140 S102M105M190 S102M140 S112M105M104 S240M105M109 S240 It works great! The only issue I have with it is that when it runs M140 then M104, it o…
-
At a higher point where resolution is approximately at it's highest, a 1mm horizontal movement is 780 steps (at 0.002°/step). At that point, 100mm/sec would be 78,000 steps/sec... It's not impossible, but i feel like it's pushing the limits of eve…
-
It might be even worse than that. I threw together a quick model in solidworks capable of a little over 200mm of vertical travel. At the center near the bottom (where I assume resolution is at it's worst), a 1mm horizontal travel in a random direc…
-
When you say C++, you are talking about re-writing some of the firmware on the Arduino, right? If so, my experience with is quite minimal, but this would be a great excuse to learn I have looked a tiny bit into the kinematics for these types of d…
-
I'm just not sure why the eeprom doesn't hold it's settings. Isn't that what it's for?
-
My guess is over extrusion. I've spent a lot of time tweaking mine just right, and when I print holes they are VERY close to the size they're supposed to be.
-
That looks awesome! It would definitely be better than the current method. I often find myself picking a certain angle to view that part at so that the "glare" is just right to see the details. This would be WAY better!
-
Maybe start with something more basic. What printer are you using? I assume it's running off an Arduino board of some type?
-
Excellent! That sounds like it'll definitely do the trick. Now I just need to figure out how to write the code
-
After playing around with it a bit, it seems to be caused by a feature of Slic3r. It only does it when Seam Position is set to "Aligned", under the Advanced section of Layers and perimeters. I may have not described it properly above. It will only…
-
The Marlin firmware settings all get set to 0 if I close Repetier. The part where you enter "steps per mm", "maximun feedrates", etc. Press Alt+E to get to it. It's definitely not an SD card problem, I don't currently use one. I did mod the firmw…
-
D'oh! Now I feel stupid :-O Just a new laptop and installed it. Totally forgot about Easy mode. Thanks!!!