myfacelackseyes
About
- Username
- myfacelackseyes
- Joined
- Visits
- 20
- Last Active
- Roles
- Member
Comments
-
I had some more time to work on the printer this evening, and my initial problem is now fixed, there is still some odd behaviour. The travel in the Z axis is about 900mm, when G30 sent, the bed moves up towards the probe, at about 400mm, the motors …
-
Thanks MartinH, it should be #define Z_PROBE_PIN ORIG_z_MIN_PIN, it seems to be working now. Well spotted!
-
How do you control the bed leveling process? It takes my printer over and hour to complete it and it crashes the sliders in the max endstops multiple times during the movement so I don't trust the output?
-
ok, but from there how does one calculate axis offsets? is that just trial and error?
-
I don't know how to access the bed height map, sounds like there is an awful lot about this firmware/host I don't know. Are there any resources I could use to find this stuff out or a walkthrough for delta calibration?
-
Ok, last question hopefully, you've been really really great thanks! I got that working with the M323 command but how do I incorporate the distortion maxtrix? The host kicks out this after running the g29 command, but the performance of the printer…
-
I spent most of this afternoon carefully calibrating the horizontal radius and I can now print much larger prints, though I am still not making use of the Z-probe, my bed is removable so it can be easily cleaned and the reason I want z-probe functio…
-
Thanks for the response repetier! Where can I get a download of .92 there is only .91 listed on the firmware page?