› ›

PixelGl1tch

About

Username
PixelGl1tch
Joined
Visits
4
Last Active
Roles
Member

Comments

  • You were exactly correct, changing around my endstops / directions ended up fixing this problem. Thank you!
    in G28 only Homes Z axis Comment by PixelGl1tch December 2019
  • I should also add that I can jog x and y in one direction only and back to "home" (being where they started when the machine powered up) and all endstops still remain un-triggered (low). However, hitting home-all or sending a G28 only homes the Z ax…
    in G28 only Homes Z axis Comment by PixelGl1tch December 2019