RiaanAspeling
About
- Username
- RiaanAspeling
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
I'm going to try and re-magnetise the top of the pin and check if it makes any difference. I will report back to this forum with the results.
-
I did play around with the values and even tried the ones on Anthony Jordan's blog here. He suggested the values are: Marlin Repetier Function M280 P0 S10 M340 P0 S648 Pin Down M280 P0 S90 …
-
With some further testing, I see the sensor does this as well when I use my finger to touch the dropped down probe. I believe this is enough evidence to show a faulty probe unless someone on this forum has found a solution.
-
Thanks for you reply, I didn't know this. Problem I have with other slicers are that they seem to not work well with my printer. They sometimes don't even switch on the hotend before printing, and I gave up trying to figure out why. I'll give the Pr…