pehesine

Comments

• Hello,I homed X and Y and started G32.First it moved to the middle of the bed, X ok, Y -5mm, to take the initial distance to the bed.The next two measurements had been right of the middle and to far in the Y direction, so the third run into the "wal…

  in Hesine M505, Activating z-probe would lead to forbidden xy position Comment by pehesine October 2019
• Hello,thanks Repetier and Matin ... as I wrote "I am far away to be a code writer" next Test with Martins (corrected) values and Repetiers corrections for P1:P1 42 14 P2 210 14 P3 42 210 M206 T3 P816 X138    (42+96) M206 T3 P820 X24      (14+10) M20…

  in Hesine M505, Activating z-probe would lead to forbidden xy position Comment by pehesine October 2019
• Hello,to be honest, I am far away to be a code writer.To find the reason, I searched with the error code.In BedLeveling.ccp I found code who might be the reason of my problem. bool Printer::startProbing(bool runScript, bool enforceStartHeight) {    …

  in Hesine M505, Activating z-probe would lead to forbidden xy position Comment by pehesine October 2019
• Hello Martin,thanks for your answer. I entered your values and controled with M205EPR:3 816 42.000 Z-probe X1 [mm] EPR:3 820 14.000 Z-probe Y1 [mm] EPR:3 824 210.000 Z-probe X2 [mm] EPR:3 828 14.000 Z-probe Y2 [mm] EPR:3 832 42.000 Z-probe X3 [mm] E…

  in Hesine M505, Activating z-probe would lead to forbidden xy position Comment by pehesine September 2019