Clonkex
About
- Username
- Clonkex
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
Eventually I figured out that the biggest issue was having the fluorescent light turned on above the printer. I was watching it do a G33 (distortion correction measuring, for any confused future readers) and wishing there was a little more light ove…
-
It's 4 mounting points. That's a good point (no pun intended). I didn't think about the fact that 4 mounting points could result in a bend. It's mounted on springs, which should help reduce that, but I'll definitely try what you suggest. I was also…
-
Ok, now that it seems to be measuring everything correctly I'm checking the heights above the bed at various points. At X20 Y20 a piece of paper moves freely even when moving down to Z0, but at X127 (20mm from right side) Y20 a piece of paper gets j…
-
Hmm actually, even after changing to these settings: #define Z_PROBE_Z_OFFSET 0#define Z_PROBE_Z_OFFSET_MODE 0#define UI_BED_COATING 1#define FEATURE_Z_PROBE 1#define Z_PROBE_BED_DISTANCE 3#define Z_PROBE_PIN ORIG_Z_MIN_PIN#define Z_PROBE_PULLUP 0#…
-
OH! I just realised what's happening! Argh I'm dumb. At the start of the G32 it's TRYING to move the probe over the current extruder position, but since I'm attempting to probe at Y10 when Z_PROBE_Y_OFFSET is 30, it tries to move the extruder to Y-2…
-
"If distance to bed is too close increase z probe height in eeprom. That increases the distance." Yes, that was my plan for later on when I get to stop running outside the bounds. "If you see the image in config tool you see it. P1 is origin, P2 s…