HansGustav
About
- Username
- HansGustav
- Joined
- Visits
- 8
- Last Active
- Roles
- Member
Comments
-
Yes, we tested the modified endstopHit function. But with no success. Still the same Problem!
-
we checked the mechanical endstop for addtional motor on the x- and y-axis axis and it works. We used a working endstop from an axis and changed it for the extra motor driver part, but the endstop is still not triggering. When we use G203 We ge…
-
I checked the pin number several times. The pin number is correct. I also tested other pins for the endstop. But always the endstop is not triggering. And I am sure, that the endstop is not defect.
-
Sorry, my mistake. Now I downloaded the dev version. We have a 32 bit board, so we did not changed anything. With the dev Version it always Returns: Motor0 Pos0.00 Endstop hit 0. The endstop hit always returns 0, also when it is triggered. And the …
-
I redownloaded and tested the new version. But still the same mistake, the endstop does not trigger. With the G203 command it always returns: Motor0 Pos 0.00. Do you have an idea why?
-
When we send M119 we have no z-max endstop. We only defined the endstop for the additional motor in the motor configuration. With the G203-command, we receive the current motor position, but no endstop status.We assume, that the error is somewhere i…
-
With the M119 command and the triggered endstop, the state off all endstops is off. We are sure that our endstop is working because we tested it on the x-axis, where it was working. We use a mechanical endstop (https://youprintin3d.de/hardware/ends…
-
Now it compiles completely. But still the same problem. The motor does not stop, when the endstop is triggered. I am sure that my settings in configuration.h are right for the additional motor. Can you help me?
-
Thank you. But now I have the following failure error. The class MotorDriverInterface has no momber named endstop hit. What is my problem now? I have no idea.
-
Thank you for your fast response. But I do not understand it.Do you mean, that I have two G203 functions in my code? I can only find one function, where should the second function be?Can you explain it more in detail?Thank you very much.
-
I always get the attached failure: Exit Status 1 - void command G203
-
I changed this settings, but also without success. Does somebody has another idea?
-
Thank you for your response. I changed the settings in drivers.h, but without success. I have still the same problem
-
Good morning,I have still a problem with my BL-Touch. The BL-Touch makes the self test and all commands are working. The only command which is not working is M340 P0 S700, to start the probing.Does somebody have an idea why? Best Regards Hans
-
Thank you. Yes, I use the BL-touch for z-min. But what is wrong with my z-min settings. I can not find the mistake.
-
Thank you, but the pin numer should be the right one. I checked it several times
-
Yes, I have an external 5V supply for the servos. The red light of the bl touch is on, but the pin does not come out by levelling.
-
I have an Arduino Due with a radds 1.6