› ›

MrComputerGhost

About

Username
MrComputerGhost
Joined
Visits
3
Last Active
Roles
Member

Comments

  • i messed about with pull ups and it didn't fix anything. all i need to do now is change the pin number but i have no idea where to find this and what to change it to. once again, i am new to this program so im sorry if this is super simple stuff
    in z-axis moves up forever Comment by MrComputerGhost June 2019
  • after a bit more playing around i have found out the the z endstop is not being detected at all. the detector should be working fine because i only changed to repetier a few days ago and it was working beforehand, even if i block the optics with a m…
    in z-axis moves up forever Comment by MrComputerGhost June 2019