DeadCthulhuWaits
About
- Username
- DeadCthulhuWaits
- Joined
- Visits
- 1
- Last Active
- Roles
- Member
Comments
-
Well that was dumb! Me I mean, I was hitting M501(Restore) to show my settings after setting M212 for some unknown reason. I meant to hit M503(Report). I have a brand new issue now but I'll start a new post as it's not relevant.
-
Well I tried the setting in Printer Settings, though it seems no matter what value I put in the z-min stops at zero, it won't go any further than that, I can see in the G-code where it is supposed to be lowering the head down but alas zero is it's m…
-
Something else strange has happened since updating Repetier-Host, the first time I shut it off and reopened it, it no longer can connect to the printer. I had to change the port the usb cable was plugged into in the back of my computer. Could some…
-
I'm running a Printrbot Simple Maker(1405) with a Rev. F4 board with stock firmware in it, can you tell me if that is the issue? Printrbot forums are telling me Printrbot Metal and Wood should be the same though I've only ever seen it done on a met…