› ›

allyerkan

About

Username
allyerkan
Joined
Visits
1
Last Active
Roles
Member

Comments

  • MartinH said: For some reason line 27 has G1 E-21800.0 if you remove this line ,all is good But why is the G92 E0 on line 28 not resetting the E ? yeap, this solved the problem. i dont know how but my start gcodes were messed up. thank …
    in Always shows the layer count 1 Comment by allyerkan May 2019
  • https://drive.google.com/drive/folders/1i85HQryBJHtQcsG3jUcXIBe2n1l1JQv-?usp=sharing Please check the link  "body.gcode" is the correct one "button cover.gcode" is the damaged one or i think it is damaged
    in Always shows the layer count 1 Comment by allyerkan May 2019
  • Repetier said: You have no extrusions, only travel moves. A layer is a new z where you extrude in the definition of host. So I guess your slicer is not creating a gcode for printing or using A instead of E for extrusion or not saying it uses …
    in Always shows the layer count 1 Comment by allyerkan May 2019