lionellvp
About
- Username
- lionellvp
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
Everything is going pretty well now, thanks for the support. Finally, I have to say, if one manages to identify the problems individually, then the solution is not difficult. Topic can be closed.
-
Repetier said: The 3cm is because you have selected left extruder. Then it will move distance to right extruder so you can select right extruder at same spot. Distance is defined by x offset. Setting it to 0 is wrong - then when you switch ex…
-
X OFFSET Dual Extruder was the answer
-
Thanks for the help, in the end I changed the engines again. In addition, I have determined with the gauge and dial gauge the correct steps per millimeter. How can you actually prevent the slide from moving 3cm to the right again after the X limit s…
-
Of course you could also say, just take the Marlin board and good, because I use a Repetier Pro server I would like to stay with Repetier.