› ›

Humbucker007

About

Username
Humbucker007
Joined
Visits
2
Last Active
Roles
Member

Comments

  • Today I tuned my stepper currents further. I raised them a fair bit and started cooluing the motors. It works fine for printing, but homing is still meh. But that's not really a concern anymore. It workes a bit better now and it's good enough for no…
    in Y-Axis behaves like Z-Axis Comment by Humbucker007 April 2019
  • When the printer tries to home, the X and y axis start moving, then get "stuck" on their axis a bit before the endstop. The there is a loud scrapping noice and i usually push the sledge on the axis towards the endstop. Close to the endstop the axis …
    in Y-Axis behaves like Z-Axis Comment by Humbucker007 April 2019
  • Hello, So i finally got to adjusting the Motor current. I played around with the values and now it's working better during printing, but when homing the axis now get stuck.
    in Y-Axis behaves like Z-Axis Comment by Humbucker007 April 2019
  • I did another print run with the 1cm³ cube. During the print the printer started hitting the Xmax-Endstop. You can clearly see the point where itstarted hitting the endstop, because then the layers work out fine, but before that they're shifted real…
    in Y-Axis behaves like Z-Axis Comment by Humbucker007 April 2019
  • I'm really confues. It get's crazier and crazier. In the begining, when using Repetier, my printer moved to the center of its bed and started printing there. Now it just stays near its zero position (and I'm still using the same gcode files).  Furth…
    in Y-Axis behaves like Z-Axis Comment by Humbucker007 April 2019
  • The drivers should all be A4988. The ramps board is set to 1/16th microstepping and the Nema 17 stepper motors do 200 Setps/revolution.  I tried setting ALWAY_CHECK_ENDSTOPS to 0, but it made no real difference at all. Is there a good/software way t…
    in Y-Axis behaves like Z-Axis Comment by Humbucker007 April 2019
  • I found this thread http://%20https//forum.repetier.com/discussion/905/have-had-someone-such-a-problem And so i went and increased the delays a bit (picture) and now the printer does not move to the center anymore when starting a print, although it …
    in Y-Axis behaves like Z-Axis Comment by Humbucker007 April 2019
  • Helllo, the Z-Axis not moving problem was resolved with reinstalling the firmware. It no moves fine, but my prints still come out slanted. I tried reducing the Jerk down to 6 and the acceleration down to 650, but the more i Reduce them, the worse it…
    in Y-Axis behaves like Z-Axis Comment by Humbucker007 April 2019
  • I still have this weird Issue, althoughmy Z_Axis now moves, the layers are still shifted really bad
    in Y-Axis behaves like Z-Axis Comment by Humbucker007 April 2019