curieux

Comments

• hi repetier "1:1" sent ------------- If I use with Cura 4.0 and the g-code "ultimaker" and sent it to the repetier Server which is configured with firmware "marlin". The print result is is bad as decribed above WHY  when the code will be sent 1:1 …

  in cura 4.0 and repetierServer pro 0.91.2 - cura: g-code flavor repetier : Firmware - Settings?? Comment by curieux April 2019
• thx  but cura 4.0 has the g-code "ultimaker" and repetier not . so there is a difference by default.  I will check the log 

  in cura 4.0 and repetierServer pro 0.91.2 - cura: g-code flavor repetier : Firmware - Settings?? Comment by curieux April 2019
• Results : marlin and RepRap settings try to Print on the UM2+ but the filament gets entangled.  the same file sliced with g-code "ulitmaker" and saved on SD card works fine no wraps around the nozzle

  in cura 4.0 and repetierServer pro 0.91.2 - cura: g-code flavor repetier : Firmware - Settings?? Comment by curieux April 2019
• can also be a problem of the g-code flavor of cura 4.0 and the setting on the repetier server . both must be equal

  in Print doesn't start with Ultimaker 2+ Ex Comment by curieux April 2019