› ›

Doc_Ara

About

Username
Doc_Ara
Joined
Visits
0
Last Active
Roles
Member

Comments

  • As per my original post - DRO = Digital Read OutThe ability to display the position of the cutting head. When do you think a mega 2560 version will become available?Thanks
    in New User - A Question Comment by Doc_Ara March 2019
  • Repetier said: No V2 has no mega HAL at the moment. You mean like the classic CNC solutions where the pc sends every step signal? I don't think so! I was just making the point that it would be good idea not to focus entirely on 3d prin…
    in New User - A Question Comment by Doc_Ara March 2019
  • HiIs there a V2 branch that is suitable for a Mega 2560? Secondly, I'd thought I'd impart some of my observations over firmware and possible future demands. With the advent of Fusion and other cheap/open source software, more and more people are exp…
    in New User - A Question Comment by Doc_Ara March 2019
  • Oh God yes please!!!!!!
    in Add-On for the configurator for the knob direction Comment by Doc_Ara February 2019
  • Hi Your current setting (via Vref) should be set for approximately 90% of the rated value of your stepper. So in your case 90% of 1.2A = 1.09AAnecdotally from the internet, the DRV8825 seems to make steppers whine in use but this does depend on th…
    in DRIVERS AND STEPS Comment by Doc_Ara February 2019
  • Many thanks - very helpful FYI - I have no previous configuration with Repetier, I'm starting from scratch. The only information I have is a branch of Marlin that the designer of the machine I'm using. Do you mean this could be imported and the se…
    in New User - A Question Comment by Doc_Ara February 2019