rdzawka
About
- Username
- rdzawka
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
Thank You Repetier very much for your quick response. Now I know understand it much better. My mistake was I tested low values of feedrate (F25, F50), which is a very low speed. Today I tried higher feedrates (F720 = 720mm/min = 12mm/s, by default …
-
Thanks for your response RAyWB and Repetier. I defined extruder and now everything works like it supposed to work in laser mode,Thanks for your help!
-
Ok, You were right. I didn't have defined extruder. Now I added new extruder, but... What pins should I choose for "temperature sensor pin" and "heater pin"? What's an extruder role in laser mode?
-
Here is my configuration.h file: /* This file is part of Repetier-Firmware. Repetier-Firmware is free software: you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Softwar…
-
I mean it is usually used for extruder heater on Ramps. In laser mode I use it only for laser output.
-
Of course I don't do my tests on laser since I've noticed that it doesn't work correctly. I measured voltage on different pins (D10, D9, D8, servos pins) searching for some laser stering signal during G1 X100 command, but without any possitive eff…
-
Well, i tried set M3 S0, M3 S50, .... , M3 S255 and i can't see any difference, laser is still on no matter I move X/Y axis or not, always on. G-code M5 (spindle off) doesn't work to. I guess it is a problem with voltage output on D10 pin but maybe…