sjmm
About
- Username
- sjmm
- Joined
- Visits
- 1
- Last Active
- Roles
- Member
Comments
-
Thanks for the quick andere. As the setting showing, jam detection is configured as switch. So end of filament should be detected. How can i check the function/configuration of switch/software?
-
Hello, i stuck at the similar problem then neoh. I am using an ramps 1.4 board and 2 extruders. The config file has the following settings: #define EXT0_JAM_PIN 3#define EXT0_JAM_PULLUP 1 #define EXT1_JAM_PIN 3#define EXT1_JAM_PULLUP 1 #define JA…