Marcel_3D
About
- Username
- Marcel_3D
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
it works! thank you!
-
I will try this tomorrow and tell you if it works. Thank you for the effort and your help.
-
finally I found a walkaround... I use P9 instead of P11 for the LED.... Pin 11 is now the Extruder cooling Fan. now M42 works. also it doesn't make sense to me why M42 on Pin 11 dont works...
-
FYI i use Pin 11 on the radds board, which is a pin for Heater 3.... could there be the problem? maybe its not suited for PMW or the M42 command? because when I send "M42 P12 S255" the extruder starts Heating ( Pin 12 is extruder 2 heater pin) and a…
-
i have deleted the M42 P11 S255 line from select command and reuploaded the firmware to the printer. i can select the extruders and use the printer afterwards, but when i send the M42 Command via repetier host, the problem is still the same.... no w…
-
i have trieed it and there was no succses i also recognized, that sending the code via repetier host, also makes the machine stop working. I have replaced the led with a fan to exclude it as a source of error.
-
I will try that on monday. Thank you for the help. Wish you a happy weekend.
-
Select "M42 P11 S255" Deselect "M42 P11 S0"
-
Thank you that works good. The problem now is that when I used this g code in the firmware the steppers stop working. When I select/ deselect the extruder via display or repetier host the light turns on an off as it should. But no movement of …