TomBola_
About
- Username
- TomBola_
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
Wow.Thank you for the fast support.The folder /var/..../printer/... was empty.I deleted file workdispatcher.sql.Now everything works fine again! I got only one warning (since the beginning and only for my Prusa i3 MK3) that every model is bigger…
-
Update.I deleted Klipper. Had all the times problems when I connected the 2nd and 3rd printer with Marlin instead of Klipper.Now I did an firmware upate to 1.1.19 for the CR10S.
-
The last 4 weeks everything works fine and it needs some seconds or up to 30sec.But since 1 week or perhaps since I am trying to install Klipper I can wait more than 10minutes without success.Operatiing system Windows 10. Tested with Chrome and Fire…
-
Found the problem. It was indeed a Klipper problem. Flashing the firmware showed ok but it really worked only with a different command like this:sudo avrdude -v -p atmega2560 -c wiring -P /dev/serial/by-id/usb....(your usb device) -b 57600 -U ou…