Radu__
About
- Username
- Radu__
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
Thanks ROCO for your involvement and for your effort to solve my problem. I downloaded the documentation and the file from the link that you indicated. I am open the configuration.h file with Repetier-Firmware configuration tool for version 0.91 and…
-
Sorry for the delay, but I was gone. As I said, I tried multiple program sources to compile but without a favorable result. I've also changed the Arduino software with an older version (someone said on a Forum that programming does not work with ver…
-
After some unsuccessful compilation attempts for the configuration file, it is now worse, even if it did not write anything in the printer. Good thing I did before anything, a beckup of everything in the printer (eeprom and flash). The printer no lo…
-
Good news, the firmware software is repetier version 0.91. Now I'm trying to overwrite the firmware in the processor with the hot-bed information, but I had some problems with the programming parameters. The motherboard is Melzi 2.0 v5. Now I want t…
-
Okay, I guess I got it right now. That's how it is. The motherboard is Melzi 2.0 PCM card ATMEGA 1284P P802M mainboard X3A.I'm going to look for a way to rewrite the included hotbed firmware from another TronXY printer.If I succeed, I will post the …
-
Thanks for the reply.No, he did not have a hotbed. I bought the hotbed.so you need another firmware.Unfortunately, I do not really understand how to do it with "See M105 response in log. If it shows B: firmware has hotbed compiled in." I'm a b…