takis

About

Username
takis
Joined
Visits
3
Last Active
Roles
Member

Comments

  • I've also tried the second wiring (black font) with same settings but #define X_ENABLE_ON 0 #define Y_ENABLE_ON 0 #define Z_ENABLE_ON 0 It works too.
    in Tb6600 Comment by takis December 2018
  • Finally it did work !These are the settings for TB6600: #define X_ENABLE_ON 1 #define Y_ENABLE_ON 1 #define Z_ENABLE_ON 1 #define STEPPER_HIGH_DELAY 40 #define DIRECTION_DELAY 2 #define STEP_DOUBLER_FREQUENCY 12000 #define ALLOW_QUADSTEPPING 1 #defi…
    in Tb6600 Comment by takis December 2018
  • Sorry, i had attached it. Configuration.txt I've tried that wiring. I'll check it again.
    in Tb6600 Comment by takis December 2018
  • I ve tried both wirings. Now i'm using the second one (Bridged En- Clk- Cw-). I've tried old Marlin version with microstep_pulse at 10 μs and it's working fine, but i don't want to use Marlin for various reasons. Ive uploaded the Configuration.Than…
    in Tb6600 Comment by takis December 2018
  • No luck guys. It doesn't spin at all. I have tried higher delays. Would you mind sharing the wiring ?
    in Tb6600 Comment by takis December 2018