Bacon117
About
- Username
- Bacon117
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
Just wanted to close the loop on this. I did have marlin configured as the communication protocol. I figured out that I must restart my PC after I have fully booted the printer. I was restarting both at the same time, and for some reason that di…
-
Perhaps I don't have attachment privileges? I'll paste the log here: 22:35:18.951: M117 Finished22:35:20.852: N1 M11022:35:20.852: N3 M11522:35:20.852: N4 M220 S10022:35:20.852: N5 M221 S10022:35:20.852: N6 G92 E022:35:22.645: start22:35:22.645: …
-
Looks like a communication error based on the console (attached), so my printer isn't responding. Any tips on narrowing down WHY this is happening? I've been over the COM settings a few time and I didn't notice anything wrong.