Drhoover001
About
- Username
- Drhoover001
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
OK, so I decided on some old fashion shotgun troubleshooting. I loaded all the same software on a Windows 10 laptop and everything fired up fine. So I have an issue with my Windows 8.1 machine. Anything in your files on 8.1 issues that would relate?…
-
I used the serial monitor just a little to verify an output from the stop button on the ramps. How do you enter expert mode. I have 1.8.8 installed, and haven't found doc on it yet, I did a search on their site, but ran into issues with the search …
-
set both ascii and auto with same result. Using windows 10. loaded marlin 1.8.8 and drivers from ide 1.8.8, shows as version 1.2.3.0 . get ascii response in Repitier log and Arduino ascii monitor when I press the start button. also Tx polling light …