dseebauer
About
- Username
- dseebauer
- Joined
- Visits
- 7
- Last Active
- Roles
- Member
Comments
-
Thanks for the feedback. I checked the md5 sum and it was correct. I believe it is a hardware compatibility with the latest version or a true hardware issue. I was able to locate the image for the previous version I had installed. The file nam…
-
FWIW, I'm running on a delta (using Repetier firmware). So home should be Zmax. When I home (via buttons on server panel) it does in fact go up to home at Zmax. LCD reports Zmax as well. However Server Control Panel shows Z at 0 (like what is…
-
Yes. I did get that message and I double checked all the settings related to notifications for the app. All was set to allow notification. It has been fixed however. I don't know for sure what did it, except that I again uninstalled the app bu…
-
Thanks for the suggestion. Unfortunately it did not seem to correct the issue. I cannot be sure but I can't say the device ID actually changed with the install/uninstall. It looks similar each time anyway. I even updated my iOS to 12.1.4 on off…
-
Thank you very much for the help. Worked perfectly!
-
Brilliant! The Y move was outside the bounds. Doh! Should have recognized that. I relocated the cable from sensor away from the steppers and LCD. It was just draped across as a temporary placement. No more false positives, so crosstalk is l…
-
Thanks for the information. I think I fixed the decoupling per your suggestion. The other issue, however is still an issue. It appears the move command is getting issued, but still not being executed. Below is the log from latest trial (bold is…