robnee
About
- Username
- robnee
- Joined
- Visits
- 26
- Last Active
- Roles
- Member
Comments
-
I forgot to thank you for this. I just downloaded 1.61 and noticed this on the download page. Thank you very much. I hope others find this useful too. Thanks!
-
Yes but you can only review the release notes if there is a new version available. Once you've upgraded to the latest version all the check update option says is, "No new updates available" with no option anymore to see the release notes. What I'd…
-
Oh, fantastic, thanks! I was actually asking if there was a way from inside RH. I like how it displays when there is a newer version available. I was wondering if there was a way to bring up this screen at any time. Rob
-
Yes. I just tried the new zoom factor feature. It works very well! I'm sure others will appreciate this feature as well. My Repetier workflow is much easier now. Thank you so much for adding this! A donation is forthcoming...
-
This is wonderful news. I look forward to trying this new feature.
-
I have just upgraded to version 1,5,2 and the mouse wheel zoom problem still exists. The main problem is the zooming is FAR too course close up and far too fine when zoomed way out. Can you please do one of two things? Disable the acceleration ef…
-
It seems that if you are zoomed out each step of the wheel zooms by a small amount but the more you zoom in the more the each subsequent step zooms in. It's as if each step is a percentage of the previous zoom level. In other words if my effective…
-
Also, can someone post a link to RH 1.02? There does not seem to be any way do download an older version and I need to older version until version 1.06 is fixed.
-
I believe I have found the problem. The offsets stored in my M212 command were: M212 X20.0 Y0.0 Z-0.5 The X20.0 was throwing things off. This happens ONLY after you execute G29 to probe the bed. If you home the extrude using G28 the offsets are…
-
This happens to a lot of people including me so it's definitely not something michkrom alone is experiencing. Not sure what is wrong. When issuing manual gcode commands to send the print head to the center of the bed of my Metal Simple with: G1 X…
-
Thanks. Setting Reset on Connect to Disabled fixed this problem!