› ›

jonas

About

Username
jonas
Joined
Visits
4
Last Active
Roles
Member

Comments

  • sorry for my long absence MaukCC already meantioned the problemmy heated bed produces too much heat during ABS printing, so i have to cool the chambermy stepper motors are in the housing, so i want to avoid temperature over 40°C. Therefore my setup …
    in Heated Chamber Comment by jonas April 2019
  • I can confirm, that this solution is working for me quiet well! But it is pretty annoying that i have to upload a new Firmware to change the Temperatur for the thermocontrolled fan, which depends if i print PLA oder ABS. Perhaps we can get a smoothe…
    in Heated Chamber/Enclosure/Housing Comment by jonas January 2019
  • It see what your intention is. How can i implement two commands? i guess it should be at: #define Z_PROBE_FINISHED_SCRIPT "G4 P500 M340 P0 S1500" but i don't get it, how to write two Commands in one line? any ideas? Then i can try on my own to fi…
    in BlTouch Delay Issue Comment by jonas November 2018
  • Not really solved, but i don't get anymore errors during homing and autobedleveling but the pin is still released too fast, so i hits the bed while it's moving away you can here this effect in the video! i don't think this is how it should work and…
    in BlTouch Delay Issue Comment by jonas November 2018
  • add:i was reading through Antlabs-Documentation There are a few points in the Marlin-Documentation which bothers me: In Marlin there are following points:#define BLTOUCH_DELAY 100#define Z_CLEARANCE_DEPLOY_PROBE 15#define Z_CLEARANCE_BETWEEN_PROBES …
    in BlTouch Delay Issue Comment by jonas November 2018
  • short reply: I changed it, but the problem won't disapear
    in BlTouch Delay Issue Comment by jonas November 2018
  • Thanks for your hints and sry for my absence I tried to follow your hints but i discoverd a new problem. After executing "M111 S64" i can't home z anymore. I have no clue why this happens. So i made 2 Videos for you guys, before and after executin…
    in BlTouch Delay Issue Comment by jonas November 2018
  • sure I have a cartesian printer but i am moving the bed in z and the head in x/y Edit: I thought i can attach the config.h file here So i will ve to post ist /*    This file is part of Repetier-Firmware.     Repetier-Firmware is free software: y…
    in BlTouch Delay Issue Comment by jonas November 2018
  • Thank you guys! I guess i can use both of your methods you mentioned, to obtain a temperature range between for example 40°C-45°C. I can heat the chamber with M104 T1 S40 and if the chamber gets too hot i can cool it with the thermocontrolled fan at…
    in Heated Chamber/Enclosure/Housing Comment by jonas August 2018