jeffgar2000
About
- Username
- jeffgar2000
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
It printed 3 things perfectly and then stopped responding again. I uninstalled and reinstalled and it started working again. Reinstalling over one doesn't work. You have to do a complete uninstall with sudo dpkg -r repetier-server and then instal…
-
"So as it looks you are uploading the wrong files which make it not work. Upload gcode and not stl and it should work again." I got those errors when i sent a print from Cura. Direct printing that exact gcode file failed, no heat and no motion. S…
-
Reinstalled the .90 version and no luck. Reinstalled the .86 version and no luck. Uninstalled and decided to go back to octoprint but then changed my mind and decided to try one more time with the .86 version and now it is working again. I did no…
-
So I save gcode for one of the items I printed a few days ago. I go to direct print, open that gcode and it refuses to heat again. I copy the commands out of this file and enter them directly into the console and the heat numbers go red and it he…
-
Logs look good up until a couple days ago. now they are full of stuff like: 21:58:03.972: T:20.23 /0.00 B:20.59 /0.00 @:0 B@:0> 21:58:03.972: ok> 21:58:03.975: echo:Unknown command: "endloop"> 21:58:03.976: ok> 21:58:03.976: echo:Un…
-
Oh yeah forgot to say that I have full manual control of moving the nozzle but it never moves while the print job is fake running and the coordinates don't change on the screen. This all worked fine for probably 2 months until 2 days ago.
-
Tested again from a fresh start of all systems this evening. I can send a print job from Cura or I can select one from my drive using direct print. The temps never turn red and they never seem to even try to heat. But, the print job progresses th…
-
Nope. Nothing in the queue. I restarted the system repetier is on and the printer several times and no luck. I thought maybe heated bed got turned off but no, it is still set correctly.Manual control from repetier but no prints start.
-
OK I finally have it working right. I tried uninstall and reinstalling the host and server and it still didn't work right. I was uninstalling Repetier host just to get it off my system and I noticed it wasn't removing the program directory or cont…
-
It does match firmware. I get the little green circles in the server setup that shows that it matches but it does not print out even close to where it shows in the preview. The 0,0 origin shows on the front corner just like it should. even then I…