_Rob_
About
- Username
- _Rob_
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
I wasn't sure if i understood you (for the firs time) but now i think that i maybe know what you wanted to say. I assume that you think i have inductive sonde, but i have microswitch and this switch is triggered by nozzle "hitting" the bed. That is …
-
Ok that was my bad that i didn't checkech what was in eeprom (there was one value whitch was 160)! Now the nozzle won't go off bed but when i run G32 it is (the nozzle) almost on the edge of glass. Whitch doesn't make sense for me (first thaught was…
-
_Rob_ said: Hello i know that this is very old, but i have same problem (when i want to calibrate the bed, nozzle wants to move over my bed). After sending i read it again and without that comma (betwen bed and nozzle) it doesn't sound like…
-
Hello i know that this is very old, but i have same problem (when i want to calibrate the bed nozzle wants to move over my bed). I have some differences in my Z-Probing but the problem is same so i guess that it could have same solution, whitch i th…