› ›

zoidberg89

About

Username
zoidberg89
Joined
Visits
4
Last Active
Roles
Member

Comments

  • Thanks, yes i will consider a electrical change in the next board i design. But for now i would like to change to firmware, so if you have any tipps please let me know
    in Homing Problem Comment by zoidberg89 August 2018
  • Hi! Thanks again for your great support.I found the problem: When i heat the extruder and my bed appearently the PWM signals interfere with x-endstop signal and it gets pretty messi. I'm thinking about changing some code in the firmware. Could you p…
    in Homing Problem Comment by zoidberg89 August 2018
  • I can see a retry when x homes (a short move back when it triggers the endstop or in my case doesnt (mechanicly) trigger the endstop). Can u give me an example how that print message code looks like? i guess its a special g-code command? Thanks for …
    in Homing Problem Comment by zoidberg89 August 2018
  • edit: just had the same issue with z-probe: m119 shows right value, but it wont  move until the z-probe triggers, it just stays where it is and makes this z-position z0. After a restart it worked fine. Thanks in advance!
    in Homing Problem Comment by zoidberg89 August 2018