› ›

larssenden

About

Username
larssenden
Joined
Visits
2
Last Active
Roles
Member

Comments

  • I have used the same gcode without M3 in it but then the laser would be off in the whole gcode program.that is just the thing I dont understand why the laser didn’t go on.
    in Laser mode E increasing Comment by larssenden June 2018
  • it will not work,when i only write M452 in gcode program laser is off the whole time.When i write this:; generated by Slic3r 1.2.9 on 2018-06-11 at 11:38:36; external perimeters extrusion width = 0.40mm ; perimeters extrusion width = 0.48mm ; infill…
    in Laser mode E increasing Comment by larssenden June 2018